TLD-141 type electric stripper operation points - Database & Sql Blog Articles

[

product name

] TLD-141

Electric stripper

TLD-141

Electric stripper

Can be used for diameters

50mm, 100mm, 101.6mm, 150mm, 152mm

Height is

230mm

The test pieces in various test molds were demoulded.

TLD-141

Electric stripper

Operation points

1

. Connect the power supply and test the positive and negative motor

,

The low speed is rising and the high speed is falling. When using electric demoulding, pull out the bakelite ball handle. Push the bakelite ball handle in when using manual demolding.

2

. According to the size of the demolding test tube, the corresponding size of the stripping plate (round and rectangular plates) is fixed on the top plate of the stripper.

Φ150mm

,

Φ152mm

When the two test cylinders are demoulded, the top plate of the instrument is the stripper.

3

. Put the test tube together with the test cover on the top of the screw and press it down

"

rise

”

Button, at this time, the screw rod rises slowly. When the upper edge of the test tube approaches the top plate of the instrument, you should pay attention to whether the center of the test tube is facing the round hole of the top plate of the stripper. If there is any deviation, stop it and find it to ensure smooth operation. The demoulding and the test piece are not crushed. At the same time, the brackets mounted on the two side columns are adjusted to the position that can be supported to the test tube to ensure that the empty mold tube is not free to fall and is damaged after the test piece is demolded. As the demoulding screw continues to rise, the test piece can be smoothly removed.

4

. Pressed after demolding

"

decline

”

The button, the motor is reversed, and the screw is quickly lowered.

5

. Since there is no automatic limit device for the lifting and lowering of the demoulding screw, the limit position of the lead screw ascending and descending must be strictly observed during operation. The screw can only be lowered within the allowable range and cannot be violated, otherwise the instrument will be damaged. If the clearance height from the top plane of the stripper to the bottom plane of the top plate of the instrument is too large or too small, the position of the top plate should be adjusted to meet the requirements (the bottom surface of the top plate should be perpendicular to the screw when adjusting).

6

. Electrical safety grounding.

Touch probe

Mud three-piece tester

Light touch probe